The composition of high temperature conveyor belt is an indispensable economic material transportation. It is widely used in the transportation industry. It can transport bulk materials, bulk materials, packaging boxes, etc., but in the transportation process of belt conveyor machinery In the process, there are often problems such as the condition of bulk materials. Bulk materials are mainly scattered in three parts, namely: the material at the transfer point of the belt conveyor, the material at the belt suspension at the concave section of the belt conveyor, and the material when the heat-resistant conveyor belt is slipping. Below we introduce Here is how to deal with the problem of material spilling on the high temperature conveyor belt
1. Scattering at the transfer point of the high temperature resistant conveyor belt: The scattering at the transfer point is mainly due to the position of the drop hopper and the guide trough on the belt conveyor machine. If the transport machine is overloaded, the heat resistant conveyor belt will appear. The skirt is damaged. In order to avoid the occurrence of the above situation, we suggest that the transportation volume of the heat-resistant conveyor belt can be adjusted to strengthen the maintenance and maintenance of the conveyor machinery and the high-temperature conveyor belt.
2. Spilling of materials when the concave section of the high temperature resistant conveyor belt is suspended: This is because the concave section will cause the belt to appear in the air. The second time will easily change the groove of the heat resistant conveyor belt. Once the groove angle of the conveyor is If it becomes smaller, the material on the conveying machine will be easily scattered. Generally speaking, when the conveyor belt has a small margin of selection, the phenomenon of material scattering will easily occur.
3.The phenomenon of slippage of the high temperature resistant conveyor belt: When the slippage occurs, it is mainly because the height of the two edges of the belt changes during the operation, one side is high and the other is low. The material will be lowered to avoid spilling, and the way to deal with it is to adjust the material’s skidding deviation.