Conveyor Belt Adhesive

Conveyor Belt Adhesive Introduction

Basic Information:
Brand: OrientFlex
Material: CR
Model: conveyor belt adhesive
Colour: Black
Whether it can be customized: yes

Conveyor belt adhesive introduction:

SA3000 two-component adhesive is suitable for bonding rubber to rubber, rubber to metal, rubber to fabric. It is especially suitable for repairing and cold seamless bonding of conveyor belts, rubber lagging of pulleys, and anti-wear and anti-corrosion rubber linings on various metal surfaces.

Conveyor belt adhesive features:

High quality – excellent bonding strength exceeds HG/T 3659-1999 standard requirements.
Convenience – simple tools can be used, no need to use large equipment such as vulcanizing machines.
Fast – In case of emergency repair, it can be repaired and used immediately, reducing the loss of downtime.
Reliable – 3 years shelf life
Applicable – Safe and flame retardant, suitable for both uphole and downhole use.
How to use and preparation:

Rubber: Use a tungsten steel grinding disc or a steel wire wheel to fully polish (no shiny surface), and then use a brush to clean off the dust (do not use water or chemical solvents).
Core: Grind off the residual glue, then lightly grind the fabric layer (be careful not to damage the fabric layer), remove the dust (do not use water or chemical solvents), if you can keep a layer of rubber with a uniform thickness, then lightly polish the rubber layer , the effect is better.
Metal: Use SA3500 cleaning agent to remove the grease on the metal surface, and then use a grinding wheel or sandblasting to polish. Apply a coat of SA3600 Metal Finisher and allow to dry completely.
Mixing: Mix SA3000 and 3000B hardener in proportion and stir well. It must be used within one hour after mixing, otherwise it will harden and fail.
Brushing: Coat the combined surface with a second uniform thin layer. The surface with CN adhesive layer does not need to apply the first layer. The first layer must be completely dry and reach the level of not sticking to the back of the finger. When the second coat is dry to slightly tacky (test with the back of your hand), the final bonding of the surface can be carried out. (Apply another layer if the second layer is too dry).
Bonding: Stick the joint surfaces together, avoid enclosing air, tightly fit and compact.

Conveyor belt adhesive precautions:

1. The working environment and material temperature are higher than 10°C. The humidity of the surrounding environment is less than 90%.
2. The bonding surface must be dry and clean, free of grease, oil and chemicals.
3. The above data are the results of on-site experiments. Because of different materials and working conditions, we recommend that you do experiments before on-site construction.
4. Unmixed SA3000 and hardener should be well sealed and stored in a cool and dry place.
5. Before the product is cured, try to avoid contact with the skin. In case of accidental contact, wash with water and soap immediately. In severe cases, please seek medical attention in time.

Conveyor belt adhesive parameters: